PDS_VERSION_ID = PDS3 RECORD_TYPE = STREAM DATA_SET_ID = "RO-E-RPCLAP-3-EAR3-CALIB2-V1.0" PRODUCT_CREATION_TIME = 2006-10-26T11:45:00 PRODUCT_ID = "RPCLAP030101_CALIB_FRQ_E_P1" LABEL_REVISION_NOTE = " 2019-10-04, EJ: Minor corrections 2019-11-26, EJ: Updated TEXT-->ASCII_DOCUMENT" ^ASCII_DOCUMENT = "RPCLAP030101_CALIB_FRQ_E_P1.ASC" ^ARCHIVE_CONTENT_DESC = "RO-IRFU-LAP-EAICD.PDF" ^RPC_SCIENCE_USAGE_DESC = "RPC_USER_GUIDE.PDF" ^RPCLAP_SCIENCE_USAGE_DESC = "RO-IRFU-LAP-UG.PDF" OBJECT = ASCII_DOCUMENT PUBLICATION_DATE = 2006-11-01 DOCUMENT_FORMAT = TEXT DOCUMENT_NAME = "Frequency response for probe 1, E-field mode measurements" DOCUMENT_TOPIC_TYPE = "CALIBRATION DESCRIPTION" INTERCHANGE_FORMAT = ASCII DESCRIPTION = " This file contains frequency response from sensor/probe 1 to the ADCs. It contains several frequency series each 401 steps long separated by headers. See example header below: -------------------------------------------------------------------------------------- Sun 06/May/2001 23:18:22 FRQRES P1 E--field 100kohm Boot on Cbias on Bias E 4kHz filter Source Amp -7.000 Freq. Amp 1 Pha 1 Amp 2 Pha 2 -------------------------------------------------------------------------------------- The header is 3 lines and the - is not part of the header. Line1: Creation date Line2: Different parameters as follows: P1 Probe/Sensor 1 E--field E-field mode, also in file name abbreviated with _E_ 100kohm This is the serial source resistance used during measurements. Boot on Boot strapping is on, can also be off Cbias Current bias on, can also be off Bias E Bias is E-field bias 4kHz Analog filter used, can also be 8KHz Source Amp Gives the amplitude of the frequency source/[dBm] Line3: Column descriptions, note Amp 2 and Pha 2 is not used. Freq Source frequency/[Hz] Amp1 Amplitude/[dB] Pha1 Phase/[Degrees] After the header comes 401 lines of data, then a new header and new data and so on. " END_OBJECT = ASCII_DOCUMENT END