PDS_VERSION_ID = PDS3 RECORD_TYPE = STREAM DATA_SET_ID = "RO-C-RPCLAP-2-EXT1-MTP025-V1.0" PRODUCT_CREATION_TIME = 2006-10-26T11:45:00 PRODUCT_ID = "RPCLAP030101_CALIB_FRQ_E_P2" ^TEXT = "RPCLAP030101_CALIB_FRQ_E_P2.TXT" OBJECT = TEXT PUBLICATION_DATE = 2017-08-09 NOTE = " This file contains frequency response from sensor/probe 2 to the ADCs. It contains several frequency series each 401 steps long separated by headers. See example header below: -------------------------------------------------------------------------------------- Sun 06/May/2001 23:18:22 FRQRES P2 E--field 100kohm Boot on Cbias on Bias E 4kHz filter Source Amp -7.000 Freq. Amp 1 Pha 1 Amp 2 Pha 2 -------------------------------------------------------------------------------------- The header is 3 lines and the - is not part of the header. Line1: Creation date Line2: Different parameters as follows: P1 Probe/Sensor 1 E--field E-field mode, also in file name abbreviated with _E_ 100Kohm This is the serial source resistance used during measurements. Boot on Boot strapping is on, can also be off Cbias Current bias on, can also be off Bias E Bias is E-field bias 4KHz Analog filter used, can also be 8KHz Source Amp Gives the amplitude of the frequency source/[dBm] Line3: Column descriptions, note Amp 2 and Pha 2 is not used. Freq Source frequency/[Hz] Amp1 Amplitude/[dB] Pha1 Phase/[Degrees] Then there are 401 lines of data, then a new header and new data etc. " END_OBJECT = TEXT END