# $Log: OIOR_PI6RSO_D_0012_MR_02____.ITL,v $
#
# Revision 1.2  2008/04/09 18:53:16  kwirth
# Checked and modified by K.R. Wirth on 9 Apr 2008.
#
# Revision 1.1  2008/04/09 11:19:28  kwirth
# Preliminary Steins MR02 OIOR sent by L. Kamp via e-mail on 6 Apr 2008.
#
# Initial OIOR for Steins approach observations - 2008/04/07 - L.Kamp
#
#=======================================================================================#
# Filename:   OIOR_PI6RSO_D_0012_MR_03____vvvvv.ROS
# Type:      Orbiter Instrument Operation Request file
#
# Description:   Observations of Steins on approach
#
# Author:   Lucas Kamp
#
#               JPL
#   
# Date:      03 Apr 2008 
#
# (c) ESA/Estec   
#
#=======================================================================================#

# This uses relative timing. The events are in the instrument level ITL.
# Times are relative to the first mode change to CTS/DualC, which is the start of
# scientific data acquisition, even though it will be Dark Sky for the initial 3+ hours.
# (Could also use times relative to estimated acquisition of signal = CA - 1 hour.)

Version: 00001

Ref_date: 01-Jan-2000  # Irrelevant because will be overridden by top-level ITL, but needed for ORFA.

Start_time: -000_00:22:00

End_time:   +000_04:49:12

#=======================================================================================#
Description: "1.   | Start of sequence."
#=======================================================================================#

-00:22:00 MIRO OFF AMRF001A # Power On MIRO via OBCP

-00:20:00 MIRO Engineering AMRF001B # MIRO Patch

-00:19:00 MIRO Engineering AMRS613A # Software Restart

#=======================================================================================#
Description: "2.   | Warm up instrument."
#=======================================================================================#

-00:16:00 MIRO Engineering AMRF008A # "MIRO USO ON v06"

-00:13:00 MIRO Engineering AMRF007A # "MIRO Cal Heat On v04"

-00:10:00 MIRO Engineering AMRF009A # "MIRO CTS Warm-up v06"

#=======================================================================================#
Description: "3.   | Change the HK Cycle Skip to prevent interference with CTS timing."
#=======================================================================================#

-00:05:00 MIRO Engineering  AMRS624A(\              # Miro Eng data slw
                                    VMRG0030 = 5)       # Eng_HK_Cycle_Skip

#=======================================================================================#
Description: "4.   | Go to CTS/DualC as soon as possible in order to stabilize."
#=======================================================================================#

 00:00:00 MIRO Engineering AMRF011A # CTS/Dual Continuum

#=======================================================================================#
Description: "5.   | After initial stabilization, do CTS internal calibration to improve"
Description: "     | accuracy."
#=======================================================================================#

+01:30:00 MIRO CTS_DualCntm AMRF030A # "CTS Internal Cal v03"

#=======================================================================================#
# Commented out last message as EPS flags an Error: Messages found after last timeline entry.
# Description: "6.   | During the actual observations we just remain in CTS/DualC mode."
# Description: "     | End of sequence at +04:49:12.  MR03 follows."
#=======================================================================================#